top of page
  • Writer's pictureMark YAN

Casting Ceramic Filter Seat

Updated: Aug 9, 2021

The ceramic foam filter should be placed on a certain filter seat.

  1. There should be 3-5mm overlap on the molten iron inflow surface;

  2. Leave a support width greater than 5mm on the outflow surface of the molten iron;

  3. There should be 1-1.5mm gap and sand collection groove around the filter;

  4. To prevent the box from crushing the filter, its upper surface should be 0.5-1mm below the parting surface(the gap between the filter and the filter seat);

1 view0 comments

Recent Posts

See All
bottom of page